Fork seals

Discussion in 'Technical & Maintenance' started by Jim C-G, May 26, 2018.

  1. Jim C-G

    Jim C-G Active Member

    It's still too damn cold out! Been going through old video and photos and put together a video on me replacing fork seals and putting in new springs a couple of years ago. Not the most complex thing in the world. I've been posting too many scenery and drone vids on my YouTube channel these days lol.
     
    Clipper likes this.
  2. skibum69

    skibum69 Active Member

    Mine are getting done too
     
  3. versys Rob

    versys Rob Active Member

    Now Jim posts a video on ST1300 fork seal replacement, after I did mine a couple of weeks ago!!! I needed to call on Murph to babysit me through it, as I ran into some challenges. Bad timing Jim!!! I am not even going to look at your video in case I did something wrong!!! I am getting my new windshield motor and mechanism today. Can't wait to get it installed and play with the button to make it go up, then down. Up then down again... Yeah. Currently I have to dismount from my perch, manually hoist my windshield, then remount. The challenges I face daily!!!!!!!!
     
    sleepyhead65 likes this.
  4. Jim C-G

    Jim C-G Active Member

    I'm sure you got it right... the new mantra for my YouTube channel is "Yes, you can do this at home."
    I was more than a little rusty and had to go looking at other YouTube videos in order to get the confidence up to do it.
    So glad you are getting back to the one button windshield.
     

Share This Page